|WOW!!! Fantastic Custom Steel Tug!!!
Low RPM Gardner Diesel, Bow Thruster, Beautiful Interior!! This Trawler is Ready to GO!!
Call today!! Don't Miss this Great tug!!
LOA: 42 ft 0 in
Beam: 13 ft 6 in
Maximum Draft: 4 ft 6 in
Engine Brand: Gardner
Engine Model: 5LW
Engine Type: Inboard
Engine/Fuel Type: Diesel
Engine(s) Total Power: 78 HP
Fresh Water Tanks: 2 (100 Gallons)
Fuel Tanks: 2 (260 Gallons)
Holding Tanks: 1 (90 Gallons)
Steel Plating is 3/16" over 1/4" x 3" and 4" traverse frames on common centers. Longitude frames connect the traverse system giving support to the vessel hull and machinery. Deck and front of Pilot house is also 3/16". Superstructure is 10 gauge. Half pipe guard rail is schedule 80. Aluminum boom and mast lowers to clear bridges if needed.
Granite counter top, SS sink, overhead cabinet and plenty of cabinet storage under counter
Positive locks on all cabinets
Propane Force # 10 SS 3 burners stove/oven, Two (2) 20Lbs fibreglass tanks in aluminum storage
Locker at cockpit after, complete with bottom vent, Trident Marine LPG control & detection system
Electric head and vanity in cabin forward separate shower room with marble seat.
Second electric head/vanity, in Salon
Brass portholes complete with screens: Six (6) in Frwd cabin, Two (2) in engine room, and One (1) in Salon head.
Overhead skylight in state-room.
Two single 40" beds with reading lights, over 6FT long closet forward, following the forward collision bulkhead, electric Head with vanity and a separate shower room complete the owner's retreat.
Dinette converts to double. Bench in salon sleeps one. Bench /Captains emergency berth in Pilot House.
The entire interior is done in cherry.
All Floors in Salon, Pilot House and State Room are 3/4"thick birch.
Pilot House doors, stern and engine room doors are heavy duty aluminum and watertight.
Three Water tight bulkheads. (One Collision forward, One after cockpit (with inspection covers) One at Engine room. )
Walk around deck 18"Complete with 1 ¼" all welded SS railing from fore to after, and upper deck.
All five (5) Pilot house window panes are 3/4" tempered glass, all the others 1/2".
Storm lexan plates over the salon windows
Heights in: Pilot House, Salon, and State room 6' 4." Walk in engine room 5' 4".
SS exhaust in place for generator installation, fuel and water connections ready.
Dual Racor fuel filters.
Two brass water strainers with SS ball valves.
Engine: 5LW Gardner 1200 RPM, with low oil pressure, and high temperature water alarms.
Trans PRN 1.96:1
Three Rule 2000 bilge pumps( all with auto/manual switches )
Steering: hydraulic, 26" wooden spoken helm wheel. Electric wiring in place ready for auto pilot.
Electrical: Two (2) 24 V starting batteries.
Five (5) AC outlets
House system: 12 V (4) deep cycle batteries.
2000 Watts inverter charger. Battery disconnects in Pilot House.
Refrigeration: Nova Cool 9.1 cubic feet, top refrigerator, bottom freezer.
Fuel tanks two (2), of mild steel in engine room 260 US gallons each, Sight gauge, overfill whistles, vents.
Water tanks two (2), SS 100 US Gallons each with pressurized hot& cold system.
Drinking water 20 US Gallons SS tank.
Holding tank SS 90 US Gallons
Vetus12 V Bow Thruster 75Kgf.
Windlass: IDEAL 2000watts double anchor windlass W/200 FT of chain and secondary rope and anchor station. Lockers under windlass base. Under Foot control switches on deck
Fortress FX 37 anchor on 200 ft galvanized steel chain, and 150 ft 5/8", 3 stand nylon anchor rope for second anchor.
Four (4) 12" cylindrical heavy duty mooring bumpers, Four (4) 3/4" black braided mooring lines
Wipers by Imtra at three front windows,
Dual electric fully SS Horn
Commercial Richie 5"Gimballed compass with compensators.
Chart reading light in Pilot house
Northstar 24 miles RADAR/GPS/NAV CHART combo
Kenwood AM/FM/CD radio with custom speakers
Shore Cable ready for TV
30AMP shore power
Unident Marine VHF DSC Radio Five
28" MOB ring
Commercial grade Navigation Lights: Port and Starboard, Anchor light, steaming light, Stern light
Two hundred (200) lbs plus, capacity swinging aluminum yardarm for hauling onboard heavy objects.
All steel sand blasted inside out, and epoxy painted 10 mil Two part epoxy paint - hull and superstructure
Antifouling painted bottom complete with sacrificing zinc (Reapplied in 2012) - Guaranteed for 3 years
Below drive assembly components are manufactured by Lunenburg Foundry, Nova Scotia and based on commercial applications. (Foundry established in 1891).
Prop shaft SS 2 ½".
Propeller is bronze "Bluenose" 4 Blade 28x22.
Rudder post SS 1 ½"complete with thrust bearing.