Radford R400 Cutter Sloop Unreserved Just Listed

Located: Tin Can Bay, Queensland

UNRESERVED - Inspection Highly Recommended

Online Auction: bidding to commence on Tuesday, 25 August 2026 and will end on Monday, 31st August 2026 at 2pm AEST

Bottom hull plate 4mm, Topside 3mm, Frames and Backbone 8mm, Floors, Skeg and Keel plate 4mm.


LOA 12.2m  LWL 11.56m  Draft 1.6m  Beam 3.6m


Weight 11 Tonne


Engine - Nissan SD23 Diecon 60HP approx. 1500 Hrs, 440mm 3 blade Bronze prop on 35mm shaft.


Sails :  main sail full battened, Reefurl headsail, Staysail, Stormjib


Mast : Deck stepped twin swept back. Barlow winches. Steering - Wheel with chain and wire to quadrant


Instruments: Raymarine. Engel Fridge Freezer, 12/240V. Dometic Hold and Cold Pressure System.   


Water : 550L in 4 stainless tanks. Fuel 


Anchor : 50lb and 30lb.  chain : 70 m  Anchor winch : Maxwell VW1200


TMC Toilet,   Wind Generator, 3 Burner Gas Stove & Oven. BBQ, Bose Entertainment system.


Coursemaster CM85i, Dometic Air Conditioning System


Batteries: Start Battery Blue Top Optima D31M. 3 x House Batteries Ultimate Extreme


For a full list of specifications, photos and an inspection contact:
Todd Anderson -   Call Seller
Email: Email Seller

or

Adrian Seiffert -  Call Seller
Email: Email Seller


To Register visit - Dealer Website


Online Auction Terms, Buyers Premium 7.5% excluding GST applies. 10% Deposit at the close of the Online Auction and balance of the purchase
price to be paid in full at settlement on or before Monda, 7 September 2026 sold in AUD DOLLARS.

DISCLAIMER: Marine Auctions offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel.   As the vessel is sold" As Is Where Is" Marine Auctions highly recommends that every potential purchaser inspect or arrange a surveyor or representative on their behalf to inspect the vessel prior to bidding