Simpson Sailing Catamaran

UNFINISHED PROJECT CONSTRUCTION. EPOXY /PLY. L. O. A. 11.3M B. O. A. 6.1M Exterior 90 percent finished to paint. Interior needs to be fitted out with all bulkheads and ring frames still in situ Two queen berths Some of the completed new work, Bridge deck cabin including hard top, cockpit, transoms, rudders, anchor lockers, alluminium fore beam engine beds, stern tubes. All decks have been stripped, reglassed and cored for deck fittings/hardware Engines Nanni 2.4 HE (kabota 10.8hp with hurth gearboxes) ss shafts and 14inch 2 blade propellers. New seals, cutlass bearings, mounts Engines have been aligned and moved forward. Rig. 12m masthead New mast step and tabernacle fitted. Boom, winches, cars etc. From original with some new inclusions such as 4m curved main sail track fitted and removed, blocks, fairleads. Sails are in good condition and are main, Genoa, asymmetrical spinnaker socked, smaller asymmetrical spinnaker. Steering system is a bullet proof cable set-up with ss commercial sheeves, ss tie rod end and 10mm spectra. Fitted, tested and removed. Aluminium hard top supports including davits and solar panel mounts have been fitted and removed. Tender bridles have been fitted to suit 3m polycraft. The inventory is large and can be viewed on inspection but some of the new items are: 5 hatches + 2 near new 2 opening port lights Maxwell 1500 anchor winch 60m 8mm short link chain 14mm rode and chain 2 Manson CQR anchors 1x40lb x 1x27lb 2 Aluminium 50lt fuel tanks 4 100lt flexible turtle water tanks 1 shurflo wash down pump 1 jabsco fresh water pump 2 Tlc 12v toilets 1x large bowl 1x standard Blue seas 12v 13 position distribution panel with amp/ volt meters 2x Blue Seas ARC battery links Various interior LED 12v lights and switch and switch panels 500amp battery switch Force 10 gas marine bbq Danforth compass Tutor 2 burner grill oven (gas) Etc 8 sheets 38mm polyurethane foam (2400x1200) 12 sheets of 4mm deck head lining finished in white satin 2 pack (2400×1200) 3 sheets deluxe engine sound insulation and rolls of foil tape (1370×800×25mm) 4 prefinished foam sandwich panels (1200×600×25mm) hd polyurethane 1/4 cube of silver ash timber (90×35) air dried Lots more bits and pieces cedar, Oregon etc Consumables like epoxy, glass mat, peel ply, micro balloons, cabosil, masking tape, primers etc The vessel is located in a marina shed in Moreton District with basic on-site accommodation via a 16ft caravan also included is a 20ft weather tight shipping container at rear door. She is large volume easy sailing cruising cat with great bridge deck clearance (approx 700mm) was a pleasure to sail and was in great condition before the refit began and will only be better on completion. $98,000 o. N. O. WIWO Contact Rob Call Seller